Clip

Introduction

The Clip tool extracts the units within the boundary data from the input spatial data.

1. Select the input data

• Input Data: Spatial data only.

2. Select the boundary data

• Boundary Data: The polygons from the boundary data will be used as a single boundary.

3. Set the output data

• Output Data Name: If no name is set, the default is “toolName_time”.

4. Submit

After completing the above settings, click Submit to start the tool.
When it finishes successfully, a message will be shown at the top of the page. You can click the Open Data button to start accessing the data or go to the Data page to view it.